Publicité
EN - Camera Mounting
1.
Place the provided Mounting Template onto the desired location. Ensure an outlet is nearby, and keep in mind the
cable length.
2.
Using a drill, drill through all 3 mounting screw holes on the template.
Note:
Drill a hole through the center of the template for your camera's cable if you plan to run it through the
mounting surface. If you are running the cable along a wall/ceiling, make sure to pass the cable through the cable
notch.
3.
Using a Phillips-head screwdriver and the provided Mounting Screws, secure the Mounting Bracket to the surface.
Optional:
If you are mounting your camera into drywall, use the provided anchors.
4.
Connect your camera's cable to the Power Adapter and plug into a nearby outlet.
5.
(Optional)
Use the provided Cable Clips and Screws to neatly secure your camera's cable to the wall.
6.
Adjust the angle of your camera:
•
Loosen the Camera Adjustment Screw to rotate your camera downwards and sideways, then tighten to
secure it in place.
•
Loosen the Mounting Bracket Adjustment Screw to rotate your camera and bracket clockwise or counter-
clockwise around the base, then tighten to secure it in place.
•
Tip:
For a sideways orientation of your camera you must rotate the mounting bracket by 90°, rotate the
camera by 90°, and then point your camera to the desired side.
7.
Remove the vinyl film from the camera lens once your installation is complete.
7
W891UA_QSG_EN-FR-ES_R1.indd 8
W891UA_QSG_EN-FR-ES_R1.indd 8
2023-07-05 1:35:43 PM
2023-07-05 1:35:43 PM
Publicité
