Westinghouse WSnow18 Mode D'emploi page 14

OPERATION
WARNING
scarves, or jewelry. They can be caught in moving
parts and cause death or serious personal injury.
WARNING
away from all electrical devices to reduce the risk of
electrocution or electric shock.
WARNING
discharge chute in the direction of people or pets.
Thrown snow or other objects can cause serious per-
sonal injuries.
WARNING
is free of stones, sticks, wires, gravel, and other ob-
jects that could be accidentally thrown by the snow
blower in any direction and cause serious personal in-
jury to the operator and others.
z Take notice of the direction of the wind before beginning.
When possible, discharge snow in the same direction as
the wind to prevent snow from being thrown back into
your face.
MAINTENANCE
WARNING
servicing the unit, stop the motor, wait for all moving
parts to stop, and disconnect from power supply. Fail-
ure to follow these instructions can result in serious
personal injury or property damage.
WARNING
side shields marked to comply with ANSI Z87.1. Fail-
ure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
WARNING
rized replacement parts. Use of any other parts can
create a hazard or cause product damage.
NOTICE
Periodically inspect the entire product
for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners
and caps and do not operate this product until all
missing or damaged parts are replaced. Please con-
tact customer service or a qualified service center for
assistance.
Do not wear loose clothing,
Keep all snow discharge pointed
Never point the snow blower or
Make sure the area to be cleared
Before inspecting, cleaning or
Always wear eye protection with
When servicing, use only autho-
z If the unit comes in contact with any type of obstruction or
debris during use, stop the snow blower, disconnect from
the power supply, remove the obstruction, and inspect the
unit carefully for damage before proceeding.
WARNING
place any body part in front of the snow blower when
the unit is operating or when the unit is plugged in.
Always ensure all moving parts have stopped and the
snow blower has been unplugged before clearing any
obstructions. Failure to follow these instructions can
result in serious personal injury.
z Some parts of the snow blower can freeze under extreme
weather conditions. Do not attempt to operate the unit
with frozen parts.
z When finished, allow the motor to run for an additional
few minutes, then turn the chute rotation lever back and
forth several times to remove any remaining snow from
the chute.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING
ids, gasoline, petroleum-based products, penetrating
oils, etc., come in contact with plastic parts. Chemicals
can damage, weaken, or destroy plastic which can re-
sult in serious personal injury.
LUBRICATION
All of the bearings in this product are lubricated with a suf-
ficient amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
bearing lubrication is required.
English
|
14
Never reach into the impeller or
Do not at any time let brake flu-