Flex FHE 1-16 12-EC Notice D'instruction D'origine page 15

FHE 1-16 12-EC
Symbols used in this manual
WARNING!
Denotes impending danger. Non- observance
of this warning may result in death or
extremely severe injuries.
CAUTION!
Denotes a possibly dangerous situation. Non-
observance of this warning may result in
slight injury or damage to property.
NOTE
Denotes application tips and important
information.
Symbols on the power tool
To reduce the risk of injury, read the
operating instructions!
V Volt
/min Rotation rate
Disposal information for the old
machine (see page 20)!
Important safety Information
WARNING!
Before using the power tool, please read the
follow:
these operating instructions,
the "General safety instructions" on the
handling of power tools in the enclosed
booklet (leaflet no.: 315.915),
the currently valid site rules and the
regulations for the prevention of
accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool may
be a danger to life and limb of the user or a
third party, or the power tool or other property
may be damaged.
The cordless rotary hammer may be operated
only if it is
for its intended use,
in perfect working order.
Faults which compromise safety must be repaired
immediately.
Intended use
The cordless rotary hammer is intended
– for commercial use in industry and trade,
– for hammer drilling in concrete, brick and
stone.
– for drilling without impact in wood, metal,
ceramic and plastic.
– to be used with suitable tools recommended
by the manufacturer for this power tool.
Safety instructions for cordless
rotary hammer
WARNING!
Read all safety warnings, instructions,
illustrations and specifications provided with
this power tool. Failure to follow all instructions
listed below may result in electric shock, fire
and/or serious injury. Save all warnings and
instructions for future reference.
■ Wear ear protectors. Exposure to noise can
cause hearing loss.
■ Use auxiliary handle(s), if supplied
with the tool. Loss of control can cause
personal injury.
■ Hold the power tool by insulated
gripping surfaces, when performing an
operation where the cutting accessory
may contact hidden wiring. Cutting
accessory contacting a "live" wire may make
exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Safety instructions when using long drill
bits with rotary hammers
■ Always start drilling at low speed and
with the bit tip in contact with the
workpiece. At higher speeds, the bit is
likely to bend if allowed to rotate freely
without contacting the workpiece, resulting
in personal injury.
■ Apply pressure only in direct line with the
bit and do not apply excessive pressure.
Bits can bend, causing breakage or loss of
control, resulting in personal injury.
Additional safety rules
■ Secure the workpiece. Clamping devices
or a vise will hold the workpiece in place
better and more safely than holding it by
hand.
■ Do not drill, fasten or break into existing
walls or other blind areas where electrical
wiring may exist. If this situation is
15