Philips MAGNAVOX FW390C Mode D'emploi page 21

RECORDING
Notes:
- For recording, use only tape of lEC type I
(normal tape) or lEC type II (Chrome).
- The tape is secured at both ends with
leader tape. At the beginning and end of
tape, nothing will be recorded for six to
seven seconds.
- The recording level is set automatically,
regardless of the position of Volume,
DBB or Incredible Surround.
- To prevent accidental recording, break
out the tab on the left shoulder of the
tape side that you want to protect
- uMCCK T PPL " is displayed, the
protection tab has been broken. Put a
piece of clear adhesive tape over the
opening. Do not cover the Chrome tape
detection hole when covering the tab
opening.
One Touch Recording
• For One Touch Recording, as soon as you
press
RECORD,
the current source will
be recorded on tape deck 2.
1 Load a blank tape in tape deck 2.
2
Press
RECORD
to start recording.
REC flag starts flashing.
3
Press ■ to stop recording.
Note:
- When you press HECOBD at TAPE mode,
'SELECT
niHER SUEPEE " will be
displayed. One Touch Becording is not
possible at TAPE mode.
Dubbing tapes
(from tape deck 1 to
tape deck 2)
1
Press
TAPE
to select tape deck 2.
2 Load the prerecorded tape into tape
deck 1 and a blank tape into tape deck
2
.
— Make sure that the tape in tape deck
1 has its full spool to the left.
3
Press
DUBBING once
for normal
speed dubbing or twice within 2
seconds for high speed dubbing.
-* TJuRiIRl" (normal speed) or
"EnST" (high speed) will be
displayed and then followed by
"Til iVVTh ifZ "
1IUUJJ±I^U .
HSD flag appears on the display for
high speed dubbing.
• Dubbing will start immediately.
— REC flag starts flashing.
4
Press
■
to stop dubbing.
Notes:
- At the end of side A, flip the tapes to
side B and repeat the procedure.
- Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
- To ensure good dubbing, use tapes of
the same length.
- During high speed dubbing in Tape
mode, the sound is reduced to a low
volume.
- You can switch to other source while
dubbing.
21