Publicité
Les langues disponibles
Les langues disponibles
OPERATION
MAINTENANCE
!
Run-on Brake
When the On/Off switch is released, the chuck brakes to a stop, thus preventing the
run-on of the tool.
When driving in screw, wait until the screw is screwed in flush with the material and
then release the On/Off switch. By doing so, the head of the screw does not
penetrate into the material.
Protection Against Deep Discharging
The Li-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the drill is switched off by means of a
protective circuit: The inserted bit no longer rotates.
Operating Instructions
Apply the power tool to the screw only when it is switched off. Rotating tool inserts
can slip off.
Soft Grip
The gripping surface (soft grip) reduces the danger of slipping and thereby
improves the grip on the drill and its handling.
At the same time, the rubber coating achieves a vibration-reducing effect.
Tips
After longer periods of working at low speed, allow the drill to cool down by
running it for approx. 3 minutes at maximum speed with no load.
For drilling in metal, use only perfectly sharpened HSS drill bits (HSS=high-
speed steel).
Before screwing larger, longer screws into hard materials, it is advisable to
predrill a pilot hole with the core diameter of the thread to approx. 2/3 of the
screw length.
CAUTINON: Place the direction of rotation direction switch into the middle
position before carrying out any tasks on the tool, e.g. changing bits or
maintenance, or before transporting or storing the device. Inadvertent operation
of the On/Off switch may result in injury.
Always pull the battery charger out of the mains socket and remove the battery
pack before you clean or maintain the device.
The cordless drill is maintenance-free.
1) Always keep the device clean, dry and free of oil or grease.
2) Clean the device immediately after you have finished using it
3) Do not allow any liquids to enter the device. Use a cloth to clean the housing.
4) Never use petrol, solvents or cleaning agents that might attack plastic.
21
Publicité
