Publicité
Les langues disponibles
Les langues disponibles
OPERATION
1) Set the rotational direction switch to the centre position in order to avoid
unintentional starting.
2) Insert the charged battery into the handle as Pic.B shown so that it can be
felt to engage and faces flush against the handle.
Switching on:
To start the appliance squeeze on the On/Off switch and then keep it pressed
down.
Note:
The power light lights up when the On/Off switch is slightly depressed, and
enables illumination of the screwing location in unfavorable light conditions.
Switching off:
To stop the appliance, release the On/Off switch.
Reversing the Rotational Direction
The rotational direction switch is used to reverse the rotational direction of the drill.
However, this is not possible with the On/Off switch actuated.
Setting the Torque
The required torque can be preselected in 20 steps with the torque preselection
ring. With the correct setting, the bit is stopped as soon as the screw is screwed
flush into the material or when the set torque is reached.
Select a higher setting when driving out screws, or set to the symbol "Drilling".
The safety clutch is deactivated in the "Drilling" position.
Gear Selection, Mechanical
Actuate the gear selector only when the drill is completely stopped.
Two speed ranges can be preselected with the gear selector.
Gear 1:
Low speed range; for screwdriving or working with large drilling diameter.
Gear 2:
High speed range; for working with small drilling diameter.
If the gear selector cannot be fully engaged, lightly rotate the driver spindle with the
drill bit by twisting the drill chuck.
Adjusting the Speed
The speed of the switched on power tool can be variably adjusted, depending on
how far the On/Off switch is pressed.
Light pressure on the On/Off switch results in a low rotational speed. Further
pressure on the switch results in an increase in speed.
Fully automatic spindle locking(Auto-lock)
When the On/Off switch is not pressed, the drill spindle and thus the bit holder are
locked.
This enables screws to be screwed in, even when the battery is empty and allows
for the drill to be used as a screwdriver.
20
Publicité
