Publicité
Les langues disponibles
Les langues disponibles
ADDITIONAL SAFETY WARNINGS
1. Secure the workpiece. A workpiece clamped with clamping devices or in a
vice is held more secure than by hand.
2. Do not work materials containing asbestos. Asbestos is considered
carcinogenic.
3. Take protective measures when dust can develop during working that is
harmful to one's health, combustible or explosive. Example: Some dusts
are regarded as carcinogenic. Wear a dust mask and work with dust/chip
extraction when connectable.
4. Keep your workplace clean. Blends of materials are particularly dangerous.
Dust form light alloys can burn or explode.
5. Always wait until the drill has come to a complete stop before placing it
down. The tool insert can jam and lead to loss of control over the power tool.
6. Before any work on the tool (e.g., maintenance, bit change, etc.) as well
as during transport and storage, set the rotational direction switch to
the centre position. Unintentional actuation of the On/Off switch can lead to
injuries.
7. Do not open the battery. Danger of short circuiting.
8. Protect the battery against heat, e. g., also against continuous sun
irradiation and fire. There is danger of explosion.
9. Do not short-circuit the battery. There is danger of explosion.
10. In case of damage and improper use of the battery, Vapours may be
emitted. Provide for fresh air and seek medical help in case of complaints.
The vapours can irritate the respiratory system.
11. Use appropriate detectors to determine if utility lines are hidden in the
work area or call the local utility company for assistance. Contact with
electric lines can lead to fire and electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes property damage or may cause
an electric shock.
12. Switch off the power tool immediately when the tool inserted jams. Be
prepared for high reaction torque that can cause kickback. The tool insert
jams when:
— the power tool is subject to overload or
— it becomes wedged in the workpiece.
13. Hold the tool only by the insulated gripping surfaces, when performing
an operation where the cutting tool may run into hidden wiring. Contact
with a "live" wire will make exposed metal parts of the tool "live" and shock the
operator.
14. Hold the tool with a firm grip. High reaction torque can briefly occur while
driving in and loosening screws.
APPLICATION
Intended Use
The HAUSSMANN XPERT drill is intended for driving in and loosening screws
as well as for drilling in wood, metal, ceramic and plastic.
Check package contents
Remove all tools and accessories from the package and check that its
contents are complete.
-- Drill
-- Impact driver
-- Multi-purpose tool
17
Publicité
