Publicité
Les langues disponibles
Les langues disponibles
How to Start
1. Set the On/Off switch
4
to build. Motor will stop when tank pressure reaches
"cut-out" pressure.
2. Turn regulator knob
7
clockwise to increase pressure
and stop when desired pressure is reached.
WARNING: Risk of unsafe operation. If any
unusual noise or vibration is noticed, stop the
compressor immediately and have it checked by
a trained service technician.
The compressor is ready for use.
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: Risk of unsafe operation. Unit
cycles automatically when power is on.
When performing maintenance, you may be
exposed to voltage sources, compressed air,
or moving parts. Personal injuries can occur.
Before performing any maintenance or repair,
disconnect power source from the compressor
and bleed off all air pressure.
Customer Responsibilities
Before each
use
Check Safety Valve
X
Drain Tank
Remove tank from
service
1-
For more information, call our Customer Care Center at 1–888–331–4569
nOTE: See Operation section for the location of controls.
To Check Safety Valve (Fig. C)
WARNING: Risk of Bursting. If the safety valve
does not work properly, over-pressurization may
occur, causing air tank rupture or an explosion.
WARNING: Risk from Flying Objects. Always
wear certified safety equipment: ANSI Z87.1 eye
protection (CAN/CSA Z94.3) with side shields.
Before starting compressor, pull the ring on the safety
valve
8
to make sure that the safety valve operates freely. If
the valve is stuck or does not operate smoothly, it must be
replaced with the same type of valve.
to "On" and allow tank pressure
Daily or after
See tank
each use
warning
label
X
X
1
Fig. C
8
To Drain Tank (Fig. A, D)
WARNING: Risk of Unsafe Operation. Air tanks
contain high pressure air. Keep face and other
body parts away from outlet of drain. Use
ANSI Z87.1 eye protection (CAN/CSA Z94.3) when
draining as debris can be kicked up into face.
WARNING: Risk from noise. Always wear proper
hearing protection during use. Under some
conditions and duration of use, noise from this
product may contribute to hearing loss.
nOTE: All compressed air systems generate condensate
that accumulates in any drain point (e.g., tanks, filter,
aftercoolers, dryers). This condensate contains lubricating
oil and/or substances which may be regulated and must be
disposed of in accordance with local, state, and federal laws
and regulations.
WARNING: Risk of Bursting. Water will condense
in the air tank. If not drained, water will corrode
and weaken the air tank causing a risk of air
tank rupture.
NOTICE: Risk of Property Damage. Drain water
from air tank may contain oil and rust which can
cause stains.
1. Set the On/Off switch
4
2. Turn the regulator knob
7
outlet pressure to zero.
3. Remove the air tool or accessory.
4. Place a suitable container under the drain valve to
catch discharge.
5. Pull ring on safety valve
8
the tank until tank pressure is approximately 20 psi.
Release safety valve ring.
6. Drain water from air tank by opening drain valve
bottom of tank.
English
to "Off".
counterclockwise to set the
allowing air to bleed from
10
on
7
Publicité
