Eastman Outdoors 38262 Instructions page 9

Assemble Grinder Housing to Main Housing
Step 1 - Make sure unit is unplugged and in the off position.
Fully insert the Grinder Housing into the front opening of the Main
Housing. Secure the Grinder Housing to the Main Housing with the
Locking Knob. Rotate the Locking Knob in the clockwise direction to
tighten. Hand tighten only. Do not use a wrench (Figure 1).
Figure 1
Assemble Feed Screw into the Grinder Housing
Insert Feed Screw into the front opening of the Head (Figure 2a and
2b). Insure that the end of the Feed Screw lines up correctly with the
drive shaft inside the Grinder Housing. Once properly lined up the
Feed Screw can be fully pushed into the Grinder Housing (Figure 3).
Figure 2b
Insert this end of the Feed Screw into
the Grinder Housing
Figure 2a
8
Figure 3