Samsung RT21M Serie Mode D'emploi page 17

STEP 2 Flooring
STEP 3 Adjust the levelling legs
A
Untitled-1 17
• The surface you install the refrigerator
on must support a fully loaded
refrigerator. (Approximately 200 lb or
90 kg.)
• To protect the floor, put a large piece
of cardboard along the path to the
refrigerator's final installation location.
• Once the refrigerator is in its final
position, do not move it unless
necessary to protect the floor. If you
have to move the refrigerator, place
thick paper or cloth such as old carpets
along the path of movement.
Level the refrigerator by manually
adjusting the levelling legs. Turn the
levelling legs clockwise to lower the
position, or turn counter clockwise to raise.
For safety reasons, adjust the front side a
little higher than the rear side.
Leave the legs at least (A) mm from the
floor as shown.
• (A) 39 mm for RT18*
• (A) 43 mm for RT21*
English 17
2017-04-10 7:31:36