camry Premium CR 4630 Mode D'emploi page 4

device (RCD) in the power circuit, with residual current rating not more than 30 mA. Contact
professional electrician in this matter.
15. The exchange of accessories may only be carried out with the device switched off.
16. The blades are very sharp. The highest caution is offered. Before replacing the mixers,
unplug the power cord from the wall outlet.
17. Only use original accessories that are included in the scope of supply.
18. Do not cover the ventilation openings in the housing during operation.
19. For washing the case, do not use any heavy cleaning agents because they can be used
to remove graphical information symbols, e.g. Signs, warning photograms, etc.
20. Never use the appliance for hot oil or grease (hot products).
21. Never touch with wet hands.
22. The appliance is not intended for crushing ice, bone and other hard products or for
grinding nuts and coffee.
23. During the mixing process, never place your hands or cutlery into the container.
24. Observe the maximum uninterrupted operating time of the unit of 15 seconds. After the
continuous operating time of 15 seconds, wait 3 minutes before turning the unit back on.
Exceeding the operating time of the appliance and the absence of sufficient breaks can
lead to irreversible engine damage.
25. When the appliance is dirty unplug it from the mains before cleaning.
26. Before first use, wash thoroughly and dry the appliance (see: Cleaning and
maintenance).
PRODUCT DESCRIPTION
1. BLENDER
a) ON/OFF switch, I speed
d) blending shaft (removable)
2. CHOPPER
a) lid b) chopping blade
3. WHISK
a)gearbox b) whisk
4. BEAKER
USING THE DEVICE
The hand blender is perfectly suited for preparing dips, sauces, soups, mayonnaise and baby food as well as for mixing and milkshakes.
1.Attach the blending shaft (1d) to the motor part (1c). Turn it until it is locked.
2.Place the blending shaft into the beaker (4). Then press the button I speed (1a) or II speed (1b).
During processing, always hold the blender with one hand and the beaker (4) in the other hand.
3. After use, unplug the device from a power socket. Remove blending shaft (1d) from the motor part (1c).
USING CHOPPER AND WHISK
Chopper: Chopper is perfectly suited for food, such as meat, cheese, onion, herbs, etc.
1.Always place the chopper bowl (2c) on the flat, dry surface. Place the chopping blade (2b) on the center pin of the chopper bowl (2c).
2. Place the food in the chopper bowl (2c).
3. Cover the chopper bowl (2c) with the lid (2a). Press and turn it until it locks.
4. Attach the motor part (1c) to the chopper's lid (2a). Turn it until it locks.
5. Press desired speed button (1a) or (1b).
During processing, hold the blender with one hand and the chopper bowl with the other hand.
6. After use, unplug the device from a power socket. Detach motor part (1c) from the lid (2a). Open the lid (2a) and carefully take off the
chopping blade (2b).
Whisk: Use the whisk only for whipping cream, beating egg whites and mixing sponges and ready-mix desserts.
1.Attach the whisk (3b) to the gearbox (3a). Turn it until it locks.
b) ON/OFF switch, II speed
c) chopper bowl
c) motor part
d) anti-slip rubber ring
4