To avoid possible injury or property damage,
OBSERVE ALL WARNINGS AND CAUTIONS.
These instructions are intended for use by qualified
installers only. The dishwasher must be installed by
a qualified service technician or installer.
In addition to these instructions, the dishwasher
shall be installed to meet all electrical and
plumbing codes and ordinances (both national
and local).
Read these installation instructions completely
and follow them carefully. They will save you time
and effort and help to ensure safety and optimum
dishwasher performance.
IMPORTANT
The dishwasher drain hose must be installed
with a portion of it at least 20 (508 mm) off the
cabinet floor; otherwise the dishwasher may not
drain properly.
This
dishwasher
residential use only, and should not be used in
commercial food service establishments.
NEW INSTALLATION - If the dishwasher is a
new installation, most of the work must be done
before the dishwasher is moved into place.
REPLACEMENT - If the dishwasher is replacing
another
dishwasher,
dishwasher connections for compatibility with
the new dishwasher, and replace parts as
necessary.
This appliance has been found to be in
compliance with CAN/CSA-C22.2 No. 167/UL
749. It is the responsibility of the owner and the
installer to determine if additional requirements
and standards apply in specific installations.
Not for outdoor use.
Important Safety Instructions
is
intended
for
check
the
existing
Inspect the Dishwasher
After unpacking the dishwasher and prior to
installation, thoroughly inspect the dishwasher for
possible freight or cosmetic damage. Report any
damage immediately. Cosmetic defects must be
reported within 30 days of installation.
NOTE: Do not discard any bags or items that come
with the original package until after the entire
installation has been completed.
indoor
1