Rowenta IMAGIN8 CF4010 Notice D'emploi page 8

CF4010 Row 037038 25/01/05
GUARANTEE
Your appliance is designed for use in the home only. It should not be used for professional purposes.
The guarantee becomes null and void in the case of improper usage.
3. GETTING STARTED
Attaching and removing accessories:
1. Slot the required accessory into the handle.
2. Turn the locking ring on the handle to lock the accessory in place.
All the accessories are attached in the same way.
To remove an accessory, simply follow the above procedure in reverse order.
Plugging in your hair styler:
• When you have attached an accessory to the handle, place the appliance in a stable position on its rest,
on a flat surface.
• Plug it in and set the On/Off switch to On (position 1).
The 'Power on' light will come on and the accessory will begin
to heat up.
• Wait a few minutes to allow your hair styler to reach its working
temperature
(2-4 min. for the "iron" accessories; 13 min. for the crimping plates).
When removing accessories, always hold them by the plastic
part – the metal parts will be very hot.
4. OPERATION
Use this product on clean, untangled, DRY hair (to avoid damaging your hair).
1 - STYLING IRONS
6 - For tight curls
10 - For loose curls
8 - For spiral curls
(ringlets)
9 - For crimped curls
- Gather a small section of hair (approx. 2 to 3 cm across).
- Press the lever to open the tong, then slip the tips of the hair between the roller and the tong.
- Release the lever to close the tong.
Check that all the hair tips are correctly wound under the tong, in the direction of the curl.
11:39 Page 8
GB