Publicité
Les langues disponibles
Les langues disponibles
GB
I-14
iden
The remote adapters ITR-14 are suitable for wireless switching of lamps and electrical
devices up to a switching power of 2300 W.
All intertechno transmitters can be used for activation.
Remote motion sensors, timers, wall transmitters, dimmer switches,
mini transmitters and much more are available.
ngat-
The ITS-10 hand-held transmitter in the set can also be used to activate all self-learn-
ing intertechno remote receivers.
Please also follow the relevant operating instructions to code another product from
oraan
intertechno.
The remote adapters ITLR-3500 and ITLR-3500T can also be switched on and off at the
learn button, without a remote control being necessary.
The battery protection strips in the handheld transmitter unit need to be
removed first. Open and close the handheld transmitter unit as shown in Fig. 2
Encoding
Have the transmitter ready and connect the adapter to the socket. Fig. 1
1.) Press the the Learn button (L) on the receiver (approx. 2 sec.)
until the green LED flashes slowly.
The remote adapter is now ready to learn for about 30 seconds.
2.) Press the required button on the transmitter ("ON").
The remote adapter switches on to indicate the new code has been accepted.
nnitel-
A maximum of 8 codes (transmitters) can be configured in total. This also makes
planned group activation very easy.
ko
Several remote receivers can be switched on and off individually or together.
Codes remain stored even after the device has been unplugged or if there is a
aan.
power failure.
How to erase codes
mitaan
To erase an individual code on the receiver, proceed as in 1.) and 2.).
In this case, however, press the "OFF" button instead of the "ON" button on the
yesti.
transmitter.
ään
To erase all stored codes (reset), press and hold the learn button (L) until the LED
flashes quickly (approx. 6 sec).
Then, press the learn button (L) again briefly.
This erases all codes.
The transmitters are not required for this procedure.
Encoding with new transmitters can now commence.
Replacing the battery Fig. 2
A 3 Volt CR 2032 battery is included.
The battery life is about three years, or long enough for 20,000 activations
To view the declaration of conformity, please visit www.intertechno.at/CE
Operating instructions
DONE!
ITI-14
Publicité
