cecotec READYWARM 2070 MAX FORCE BLACK Manuel D'instructions page 36

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Power regulator
2. Temperature knob
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
This device is packaged in a way as to protect it during transport. Take the device out
-
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
Make sure all parts and components are included and in good conditions. If there is any
-
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
3. OPERATION
1. Before inserting the plug into an outlet, make sure that the power supply in your area
matches the rating label on the appliance.
2. Carefully remove the heater from the plastic bag and the cardboard box.
3. The heater must be placed on a firm and levelled surface.
4. Your heater is equipped with a 4-position rotary switch.
Remove all packaging materials and place the device in the desired location.
-
Make sure that the appliance is in a safe place, between furniture and curtains, with a
-
safety distance of 50 cm to the sides and 120 cm to the front.
Unwind the power cord and connect the plug to a properly installed outlet.
-
Power regulator
-
Switch off: turn the heat selection switch to the "O" position, the heater will stop operating
-
and the indicator light will go out.
Fan mode: select the first position.
-
Heating at reduced power: turn the selector (right) to the second position "I", for operation
-
at 1000W.
Full power heating: turn the selector (right) to the third position "II", for operation at 2000W.
-
36
READYWARM 2070 MAX FORCE BLACK