Publicité
Symbols in these Instructions for Use
Important information for your safety is specially marked. It is essential to comply with these
instructions in order to avoid accidents and prevent damage to the machine:
WARNING:
This warns you of dangers to your health and indicates possible injury risks.
CAUTION: This refers to possible hazards to the machine or other objects.
NOTE: This highlights tips and information.
1 On/off switch
2 Fastening head for the dust container
3 Handle
4 Eye for the hooking of the shoulder strap (rear)
5 Vacuum nozzle
6 Eye for the hooking of the shoulder strap (front)
A Hose with crevice nozzle
B Small brush nozzle
C Shoulder straps
D Large brush nozzle
E Filter
1. Check whether the filter is inserted correctly on the front of the device.
2. Open the vacuum with the fastener (2).
3. Close the vacuum again by inserting the flap on the front in the relevant slot.
4. Close the vacuum by locking into place the upper flap.
5. Mount the desired accessory with or without the hose on the front of the vacuum.
When using the hose make sure that the curved side is facing down.
6. Connect the device to a duly installed 230V, 50Hz protective contact socket.
To start the vacuuming, press only the On/Off (I/O) switch.
Since the device has a removable and washable filter, there is no need to buy spare
dust bags.
-CB 947.indd 33
Operating components
Supplied accessories
Putting the Appliance into Operation
GB
33
17.11.2009 15:55:19 Uh
Publicité
