Royal Sovereign Pro FAM-2000 Manuel D'instructions page 4

The air mover is intended to move air and to dry floors, carpets, walls, furniture,
etc.
1. Plug the power cord into a 3 prong GFCI (Ground Fault Circuit Interrupted )
protected outlet.
2. Place the unit on a stable, flat and dry surface.
3. Adjust the unit angle (0°, 20˚, 45°, 90°).
4. Turn the unit 'ON' and set the desired unit to the desired fan speed
(low, medium, high)
5. If required, turn the Timer On (0-180 minute selectable)
Important Note: The total amperage must be lower than a total of 12A. In the event
the unit stops operating when using multiple units, press the RESET button to reset the
circuit.
1. To keep the air mover, clean, use a damp cloth to wipe the surface of the housing.
Never use harsh chemicals or abrasive cleaners.
2. Never clean the air mover with water and never immerse the fan or cord in water.
3. When not in use, unplug and store the air mover in a dry indoor place out of reach
of children.
4. Always disconnect the air mover from its power source before performing any
maintenance or cleaning.
OPERATION
CARE AND MAINTANANCE
-4-