Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
Issues
Jobsite Refrigerator™
does not work
Jobsite Refrigerator™
compartments are too
warm
Food is frozen
There is a noise
sounding like flowing
water from inside
There are waterdrops
around the casing or
door gap
The compressor is
slightly noisy when
starting
Code F1 displayed
Code F2 displayed
Code F3 displayed
Code F4 displayed
Code F5 displayed
Code F6 displayed
Code F7 or F8 displayed
www.newair.com
Cause/Suggestions
Check that the plug and socket are connected properly.
Check the fuse. If it is burnt, contact customer service.
Check the power supply to see if it is damaged.
Turning ON/OFF the Jobsite Refrigerator™ frequently may
cause the compressor to delay turning on.
The door is opened frequently.
A large amount of warm or hot food was stored recently.
The refrigerator has been disconnected for a long time.
The temperature was set too low.
This is a normal sound caused by the flow of refrigerant.
This is a normal occurrence. Moisture will condense to
water when it touches a cold surface on the Jobsite
Refrigerator™.
It's a normal occurrence. The noise will be reduced after
the compressor works stably.
Low voltage to fridge. Adjust the battery protection from
High to Medium or from Medium to Low. When the F1
fault is displayed for more than 1 minute, the cooling
compartment will automatically shut down.
Condenser fan is overloaded. Disconnect power to
fridge for 5 minutes & restart. If the code shows again,
contact manufacturer for service.
The compressor starts too frequently. Disconnect power
to fridge for 5 minutes & restart. If the code shows again,
contact manufacturer for service.
Compressor not kicking in. Disconnect power to fridge
for 5 minutes & restart. If the code shows again, contact
manufacturer for service.
Overheating of the compressor & electronics. Disconnect
power to fridge for 5 minutes & restart. If the code
shows again, contact manufacturer for service.
No parameter can be detected by the controller.
Disconnect power to fridge for 5 minutes & restart.
If the code shows again, contact manufacturer for service.
The temperature sensor is faulty. Contact manufacturer
for service.
EN
8
Publicité
