Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
CONTROL PANEL SETTINGS
• Power Supply: Connect the power cord to the DC 12V/24V or AC 100-240V power
source.
• Power ON/OFF: Press the ON/OFF button once to switch on. Hold the ON/OFF
button until the screen turns off.
• Temperature Setting: Press + or - to adjust the temperature. The setting will be
automatically saved after 3 seconds of inactivity (Note: The displayed temperature is
the current compartment temperature). Temperature setting range: -20-20°C (-4-
68°F).
• Battery Protection Mode: Turn on the Jobsite Refrigerator™. Hold until the screen
flashes, then press
(Low) (The factory default setting is H).
Voltage Reference:
DC 12V
INPUT
MODE
CUT OUT
L
8.5V
M
10.1V
H
11.1V
Note: The voltage may change in different ambient temperature scenarios. H should be
set when the product is connected to car power, and M or L should be set when it is
connected to a portable battery or other back-up battery.
• Temperature Unit Setting: Press
press
to switch from E1 to E5. While E5 mode is flashing on the screen, press
t
wice to select Celsius or Fahrenheit. (*Factory setting is °C.)
• Reset: Press
+
and
+
–
press
and
at the same time until the screen resets.
• Rechargeable Battery (optional): Place the detachable battery into the battery
compartment, then connect the refrigerator to DC12/24V or AC100~240V power
supply to charge the battery, and the LED display will show the charging status. *
*The Jobsite Refrigerator™ will charge only a Newair detachable battery. Power tool
batteries must be charged using their own dedicated charger.
www.newair.com
again to select the protection mode: H (High), M (Medium), or L
CUT IN
10.9V
11.4V
12.4V
+
and
–
at the same time until E1 displays. While E1 mode is flashing,
DC 24V
CUT OUT
21.3V
22.3V
24.3V
–
at the same time until E1 displays. Then
EN
CUT IN
22.7V
23.7V
25.7V
+
-
or
6
Publicité
