Publicité
Les langues disponibles
Les langues disponibles
Material
Solid Wood
Veneer
Chipboard
Plastics
Steel
Paint Removal
Balsa Wood
Acrylic
5. HAND GRIP AREAS (See Fig. E)
Always hold your belt sander firmly with both hands
when operating.
6. CHANGING A SANDING BELT
WARNING! Remove the main plug from the socket
before changing sanding belt. Pull the lever (9) to release
the belt tension. Remove and fit a new belt over both
rollers (See Fig.F). Ensure the direction of rotation arrows
on the belt and the sander are the same. Close the lever
to tension the belt.
7. BELT CENTERING CONTROL
WARNING! Wear eye protection before carrying out
a belt centering adjustment.
Turn the machine upside down, hold it firmly with one
hand, start the motor and release the switch immediately
after observing tracking of sanding belt. If abrasive belt
runs outward, turn tracking adjustment knob counter-
clockwise and clockwise if belt runs inward (See Fig.
G). Adjust the belt until the outer edge of the belt is even
with the outer edge of the base-plate (12). Belt life will be
greatly increased by keeping the tracking adjustment set
properly.
8. DUST BAG (See Fig. H)
You must use the dust collection bag provided to collect
the dust produced during sanding. The dust collection
bag plastic bracket slides down onto the dust outlet
on the belt sander. When the dust collection bag is full,
remove and empty by opening the zip on the dust bag
(13).
202107 Belt sander 900W
Speed selection
5-6
2-4
1-5
2-5
5-6
6
1-3
1-2
SAFETY AND OPERATING MANUAL
Belt Grit
80
150
60/80
100
80
40/60
100
100
20
2
9
12
D
F
G
H
Publicité
