Krups Essential EA8150 Mode D'emploi page 27

■ A screen indicates that the appliance is heating up. Once the appliance has finished heating up, you can begin to
make steam by pressing START
Step 1: holding the milk jug in place, insert the steam nozzle approximately 2 cm into the milk and wait for it to
start frothing.
Step 2: raise the container slightly (approximately 1 cm). Do not completely submerge the metal tube.
Step 3: gradually lower the container as the froth accumulates. (14)
■ When you have frothed the milk enough, press the STOP button
stop immediately.
■ To remove any milk traces from the steam nozzle, place a container under the nozzle and start the steam function
again (approximately 10 seconds).
■ The steam nozzle is removable in order to allow for deep cleaning. Wash it with water and a little non-abrasive
detergent using a brush. Rinse and dry (15-16). Before replacing, make sure that the air holes are not clogged with
milk residue. Unclog the holes with the needle supplied with your appliance if necessary (17).
■ To stop the steam, press the STOP button
WARNING: THE CYCLE DOES NOT STOP IMMEDIATELY.
Steam can be produced for a maximum of 2 minutes per cycle.
Auto-cappuccino XS 6000 set (sold separately)
■ This auto-cappuccino accessory enables you to make cappuccinos or lattes (18). Connect the different parts to
each other. Ensure that the pipe is not pierced by keeping the knob in the correct place.
■ After removing the lid, fill the jug with milk (19) and place a cup or glass under the auto-cappuccino nozzle (20).
Select cappuccino or latte on the special nozzle (21).
■ Start steam, as indicated in the chapter Making drinks with steam.
■ Once you have made the milk froth, place your cup under the coffee jets and start a coffee cycle (22).
To prevent the milk from drying on the auto-cappuccino accessory, ensure that you clean it thoroughly. You are advised
to wash it immediately by running a steam cycle with the accessory jug filled with water in order to clean the inside
of the nozzle. For this you can use the KRUPS liquid detergent available separately.
MAINTAINING YOUR APPLIANCE
Emptying the coffee grounds collector and the drip tray
■ If the
symbol starts flashing, empty and clean the drip tray (the drip tray may contain coffee grains) and the coffee
grounds collector (23-25).
■ The drip tray is fitted with floats which indicate when it needs to be emptied (26). Once you have removed the coffee
grounds collector, you should empty it completely in order to avoid any overflow.
■ The warning message will continue to be displayed if the coffee grounds collector is not pushed in or inserted
correctly (24). You cannot make an espresso or a coffee while the warning message is shown.
Rinsing the circuits :
Press the maintenance and settings button
.
If necessary, using the navigation button,
Press START , rinsing starts and finishes when the coffee menu appears.
, and following these steps (13):
.
(27). The function indicator
select the rinse symbol
to stop the cycle. Warning: the cycle does not
is shown above the maintenance button
.
25