Philips Aquazur HI835 Mode D'emploi page 12

ENGLISH
12
during ironing), the calc-clean function should be used more
frequently.
1 Make sure the appliance is unplugged.
2 Fill the water tank until it is half full.
Do not put vinegar or other descaling agents in the water tank.
3 Put the plug in the wall socket.
C
4 Set the temperature dial to the calc-clean position. Set steam
control to position 4.
C
5 Hold the iron over the sink, press and hold the calc-clean
button and gently shake the iron to and fro.
Steam and boiling water will come out of the soleplate. Impurities and
flakes (if any) will be flushed out.
6 Release the calc-clean button as soon as the water in the tank
has been used up.
Repeat the calc-clean process if the iron still contains a lot of impurities.
After the calc-clean process
- Put the plug in the wall socket, set the temperature dial to position
2 and let the iron heat up to allow the soleplate to dry.
- Unplug the iron when it has reached the set ironing temperature.
- Move the hot iron gently over a piece of used cloth to remove any
water stains that may have formed on the soleplate.
- Let the iron cool down before you store it.
Storage
1 Make sure the appliance is unplugged.
C
2 Empty the water tank.
3 Put the iron on the rubber mat and let it cool down sufficiently
before you store it.
Replacement
The Philips Aquazur has a disposable anti-calc cassette that filters the
water in the water tank. After some time the cassette will be saturated
and should be replaced by a new one. How often the cassette should
be replaced depends on the water hardness in your area and how
often you use the iron.
- If the water is very hard, replace the cassette every 3 months.