Publicité
Les langues disponibles
Les langues disponibles
10. Attaching the Belt Clip
Follow the instructions below to attach the included belt
clip to the transmitter.
1. Align the belt clip to the grooves on the back of the
transmitter.
2. With a firm grip, screw on the belt clip's Phillips head
screws with a screwdriver.
Caution
Tighten until firmly in place. Be careful not to over
tighten.
26
11. Using the Test Light
1. Turn on the receiver by placing the magnetic red dot
on the back of the transmitter to the red dot on the
receiver. The indicator light on the receiver will come on
for a moment then blink once every 4 seconds, showing
that the receiver is ready to use (the receiver needs to
be charged if the indicator light is red).
2. Turn the transmitter on by holding down the on/off
button on the right side of the transmitter. The LED will
blink every 4 seconds and the LCD screen will show
the remaining battery life (the transmitter needs to be
charged if there is only 1 bar showing on the battery
icon for the LCD transmitter screen).
3. Place the test light, included in the package contents,
on the contact points as shown in the diagram.
4. Watch the test light as you press the Nick button on
the transmitter. It should light up for just a moment.
The higher the intensity, the brighter the test light will
be.
27
Publicité
