Dogtra EDGE RT Manuel Du Propriétaire page 11

* Caution: Tighten until firmly in place. Be careful not to
over tighten.
To shorten the contact points back to the standard 5/8",
start with the adjustment tool with the side marked 3/4",
remove the contact point extensions, and tighten the
contact points with the adjustment tool with the side
marked 5/8".
18
10. Code Setting
Follow the steps below to code an EDGE RT transmitter to
a new or existing receiver.
1. Set the Selector Dial to level 1
and set the Dog Selector Dial
to the number you want to
code the receiver to.
2. With the receiver turned off,
place the red dot on the back
of the transmitter to the red
dot on the receiver. Hold the
two red dots together for
about 5 seconds until the
green LED blinks rapidly on the
receiver.
3. While the green LED is rapidly
blinking on the receiver,
separate the two devices and
press the top orange button
on the front of the transmitter
and the Pager button on
the back of the transmitter
simultaneously. The LED light
on the receiver will blink every
4 seconds when coding is
complete.
19