Wilfa POWER FUEL 1800 Manuel D'instructions page 15

minutes to prevent any burnt smell due to overheating. Too large a quantity
of ingredients may lead to overloading and overheating of the motor. In this
case, wait until the motor temperature falls before operating again.
• Add liquids and soft foods before putting in hard food or ice cubes.
• When the operation finishes, wait until the blade assembly comes to a
complete stop before removing the blender jug. Otherwise, the drive gear
may be damaged.
• If you notice a scorched smell from the blender, stop the operation
immediately. It may be caused by abrasion of the rubber cushion base if this is
not properly assembled.
• When blending thick and sticky food at high speed, please start the operation
at low speed. If there is still no rotation, disconnect the power and stir the
contents of the blender jug using a rubber stirrer to drive out air trapped in
the food. Then close the lid and switch on to resume operation.
• Do not operate for more than 10 minutes at a time.
POWER FUEL 1800 · PB-1800B
13
EN