Wilfa POWER FUEL 1800 Manuel D'instructions page 13

• Disassemble all removable parts before cleaning.
• Clean all removable parts in lukewarm water with dishwashing liquid.
• The jug can be rinsed with water. It can also be cleaned by pouring 2 cups
of water into the jug, closing the lid and then operating the blender in Pulse
Mode. Pour out the water, rinse with clean water, and dry with a soft cloth.
• Use dry cloth to clean the main body.
Note: Be careful when cleaning the parts. Avoid touching the sharp blades!
TROUBLESHOOTING
If the blender is not working properly, please check the following:
Problem
Blender does not
start
Blender stops
Content does not
blend properly
The blender will
not start, and the
display is blinking
POWER FUEL 1800 · PB-1800B
Possible reasons
Check the power plug
Check if the jug is
properly placed
The blender has run
more than 10 minutes
Motor is overheated:
The motor has stopped
temporarily due to
overload
Not enough fluid
The indicator is not set
to 0
11
Solutions
Plug into power socket
Place the jug correctly on the
motor unit
Let the motor cool down
Reduce the amount of
ingredients and wait for the
unit to cool down
Use the tamper, or consider
adding more fluid in the jar to
help circulation
Turn the wheel so the indicator
is set to 0
EN