Télécharger Imprimer la page

Cozzia Qi SE CZ-710 Manuel D'installation page 4

Les langues disponibles

Connect wires in footrest. Connect both footrest wire connectors and screw the caps tight. Then connect the

air hose.

Caution:

After the wire connectors have been connected the cap must be screwed tight.

Here is what the four pin connectors look like.

Fully connect footrest to base. Move the footrest closer to the chair. Engage the joints of the footrest and the base.

Lift footrest up to align the holes on the joints, then insert the bolt and lock it with cotter pin (that you had set aside).

Here is what the eight pin connectors look like.

Here is what is should look like with all wires connected.

Open box 2 with side boards. Take out the side boards. Detach the cover from the side board.

Here are the two side boards.

Here is what it will look like after you detach the side

board cover.

Attach the right side board. Remove the cable tie to release the air hose ﬁrst. Then ﬁx the ﬁve

double-threaded screws onto the frame.

Here is the cable tie you are to cut oﬀ.

Here is how you detach the side board cover.

Here is what it will look like once you have fastened in the

double-threaded screws.