Cozzia Qi SE CZ-710 Manuel D'installation page 3

2 Adjust chair position. Use the power cord to connect the chair to the power supply and turn on the power
switch. The chair will go back to home position. Then disconnect the power cord.
3 Open box 3 with footrest. Take out footrest and remove the cotter pin and bolt and put aside.
Here is where the cotter pin and bolt are located.
4 Remove cotter pins and bolts from chair base. Locate the two cotter pins and bolts on the chair base.
Take them off and put them aside, then take off the cable ties to release the link rod.
Here are the cotter pins and bolts.
Connect footrest to base. Move footrest closer to the chair. Engage the link rod with footrest joint. Then insert
5
the bolt and lock with the cotter pin.
Here is what it will look like after the cotter pins and bolts
have been removed