Bradley Verge LVA Serie Installation page 10

LVAD2
5
Strainer and Drain Cap
Faucet and soap removed for clarity.
Drain cap is labeled front and back.
Be sure front is facing the user. Top
surface of drain cap should be sloped
away from user.
Position drain cap over
trough strainer, aligning
tabs into drain. Push
A
drain cap down until drain
cap is flush with basin.
Grommets should hold
drain cap securely against
drain tough walls.
To remove drain cap,
carefully slip flat
B
screwdriver into left or
right hand corner of
drain cap and gently lift
upwards.
6
Adjust Temperature with Water Running
WARNING This valve is NOT factory
preset. Upon installation,
the temperature of this
valve must be checked
and adjusted to ensure
delivery of a safe water
temperature. Water in
excess of 110°F (43°C) may
cause scalding.
10
A
Loosen Cap Screw about ¹⁄₄" (4-6
turns) and lift up cover (do not
remove).
Using cover, turn cartridge gently until
B
desired water temperature is reached.
Do not turn past stops as this may
damage unit. Push cover down and
tighten screw.
1/21/2021
1 station shown, 2 station similar.
Front
Bradley • 215-1850 Rev. E: ECO 20-08-028B
Installation
Note Angle of
Drain Cap
C
H