Publicité
Les langues disponibles
Les langues disponibles
Remote controller's operation
When in use, put the signal transmission head directly to the receiver hole on
•
the indoor unit.
•
The distance between the signal transmission head and the receiver hole
should be within 7 m without any obstacle as well.
•
Don't throw or knock the remoter controller.
When electronic-started type fluorescent lamp or change-over type fluorescent
•
lamp or wireless telephone is installed in the room, the receiver is apt to be dis-
turbed in receiving the signals, so the distance to the indoor unit should be
shorter.
Laoding of the battery
Load the batteries as illustrated. 2 R-03 batteries, resetting key (cylinder)
Remove the battery cover:
Slightly press "
" area and push down the cover as illustrated.
Load the battery:
Be sure that the loading is in line with the "+" / "- ". request as illustrated on the bot-
tom of the case.
Put on the cover again.
Confirmation indicator:
In disorderation, reload the batteries or load the new batteries after 6mins.
Note:
Used two new same-typed batteries when loading.
If the remote controller can't run normally or doesn't work at all, use a sharp
pointed item to press the reset key.
Hint:
Remove the batteries in case unit won't be in usage for a long period. If there are any display after taking-out, just need to press
reset key.
Power failure resume(please set and apply as necessary)
If sudden power failure occurs, the unit will resume original operation when power is supplied again.
Note:
When sudden power failure happens during unit operation in power failure resume mode, if the air conditioner is not desired
for use in a long period, please shut off the power supply in case that the unit automatically resume operation when power is re-sup-
plied, or press ON/OFF to turn off the unit when power resumes.
PARTS AND FUNCTIONS
57
Publicité
