Klarstein BAROSSA 102 DUO Mode D'emploi page 39

Problems
The door does not close properly
LED display is not
working properly
In the event of a breakdown
Despite the care we take during production, a breakdown can never be totally ruled
out. Before contacting your retailer's after-sales department, please check that:
• the appliance is properly plugged in;
• there is not a power cut in progress;
• the breakdown is not one of those described in the table at the end of this manual.
If the mains cable supplied is damaged, it must be replaced by the manufacturer, a
centre approved by the brand or by the retailer. In all cases, it must be replaced by
qualified personnel, so as to avoid any risk of injury.
Possible Causes
• The appliance is not level.
• The door seal is dirty or damaged.
• The shelves are not positioned correctly.
• A part of the contents is preventing the door
from closing.
• Control panel failed
• Power PCB has broken
• The appliance is not plugged in
• The probe is not working.
EN
39