Publicité
8
| English
ENGLISH
SAFETY MEASURES
Read carefully the operating instructions before
assembling and starting. The appliance must not
be used by persons who are not thoroughly ac-
quainted with the instructions handbook (operat-
ing instructions). Children and persons under the
age of 16 cannot use the pump and must be kept
well away from the appliance when it is connect-
ed. The user is liable towards third parties in the
area where the appliance is in operation.
While the pump is operating, persons must not be
in the liquid to be pumped. The pump may be con-
nected only by means of a safety switch for fault
currents, with a rated opening current up to 30
mA and a socket with an earth contact installed in
conformity with the regulations.
Protection: at least 10 Amps.
Operation in swimming pools and garden ponds
is admitted.
CAUTION: Before checking, connect the pump
and the system with no voltage!
Replacing the line connecting up with the mains
requires using special tools and therefore may be
done only by the manufacturer or its service en-
gineers. The pump may operate only with a pipe
connecting the appliance (extension) that is no
lighter than a rubber hose mod. H07 RNF in con-
formity with the DIN57282 or DIN 57245 standard.
(For your safety)
The voltage (230 Volts alternating current) indi-
cated on the pump's rating plate must correspond
to the available mains voltage. Before starting it is
necessary to make sure by having a check made by
qualified personnel that there are the necessary
electrical protection measures.
Earth connection.
ƒ
Earthed neutral.
ƒ
The safety switch for fault currents corresponds
ƒ
to the safety regulations of the electricity board
and functions perfectly.
Plug connections must be protected from wa-
ƒ
ter.
If there is a risk of flooding, plug connections
ƒ
must be placed somewhere safe.
Definitely avoid pumping aggressive liquids and
ƒ
abrasive products. In the event of the pump fail-
ing, repair work may only be carried out by the
repair workshops of the technical service.
Only genuine spare parts must be used.
ƒ
It is notified that in conformity with the law on
ƒ
product liability we cannot be held responsible
for the damage caused by our appliance:
1. because of improper repairs not carried out by
the personnel of the assistance points autho-
rized by us;
2. or if GENUINE SPARE PARTS are not used to
replace parts;
3. or if the indications and provisions given in the
instructions handbook are not complied with.
The same provisions hold for the accessories.
RESISTANCE
The maximum temperature of the delivery
liquid should never exceed +35°C in continuous
operation. Inflammable, combustible or explosive
liquids cannot be conveyed with this pump!
In particular, do not use engine fuels, detergents,
or other chemical products.
USE
CAUTION: Sector of use
1) DRAINAGE PUMP: To transfer and empty
fresh to slightly polluted water from rainwater
barrels and casks.
2) VORTEX: To transfer water with solids in
suspension. Also used as emergency pump,
in case of over-flowing with muddy water,
thanks to its large suction filter.
To achieve excellent motor cooling the pump cas-
ing is provided with a breather hole that enables
water to flow out. The pump must be protected
from running dry.
STARTING
First put the pump into water and then connect
the plug. The pump is ready for use.
BEFORE STARTING
Installation of your canned motor pump is:
fixed with a fixed pipe, or
ƒ
fixed with a flexible hose.
ƒ
TAKE CARE
When installing it is necessary to take care that
the pump is always placed in a raised position
with respect to the bottom of the well so that the
muddy bottom is not sucked up with the water.
Never handle or hang the pump by gripping the
power supply cable.
In pumps with a floating switch, the latter is
adjusted in order to make immediate starting
possible.
NOTE:
The pump well must have minimum dimensions
of 40x40x50 cm so that the floating switch can
move freely. It is also possible to use round,
prefabricated concrete wells with an inner
diameter of approx. 40cm.
MAINTENANCE INSTRUCTIONS
Your canned motor pump is a quality product, free
from maintenance. It has been subjected to rigor-
ous final checks. However, for a long service life
and continuous operation, we recommend con-
stant care and regular checks:
Before every maintenance job, disconnect the
ƒ
plug.
For transportable use the pump should be
ƒ
washed with clear water after every use.
For fixed installation it is recommended to
ƒ
check the operation of the floating switch every
Publicité
