Adjusting The Beverage Tank Temperature; Emptying The Dispenser; Cleaning, Care & Maintenance - Polar CF760 Mode D'emploi

Operation
Filling
1. Switch Off the dispenser.
2. Remove the lid and pour the liquid into the
tank.
3. Replace the lid.
WARNING: Do not fill the tank
with hot liquid.
Do not let the level exceed the
'MAX' level line displayed on the
front of the tank.
Note: CF761 Only - If only one
tank is to be filled, it must be
the left tank. To use left tank
only, you just need to switch left
stirring switch ON (I position).
Meanwhile, the right tank does
not chill and the paddle does
not run.
Using the Dispenser
1. Turn On the
7
Power switch
on the side of
the dispenser.
2. Switch the
stirring switch
to the 'On'
position [I].
3. Once the liquid is sufficiently cooled, push the
receptacle against the tap lever to dispense the
liquid.
Note: Should the paddle
encounter any resistance in the
liquid, it will reverse direction.
Adjusting the Beverage tank
temperature
To adjust the temperature of beverage tank(s), lift
up the plastic cover(s).
As CF761 has 2 tanks, Tank 1 is the one on the left
hand side of the unit when looking from the front.
CF760_CF761_ML_A5_v8_20191014.indb 5
1. Turn on the main switch on the right hand
2. To set the temperature of Tank 1, press
3. Repeat above operations to set the
4. During use, the unit will automatically display
5. To switch off the cooling of a certain tank,

Emptying the Dispenser

Drain the dispenser by using the tap lever(s) to
Model: CF761
empty the tank(s).
Cleaning, Care &
Maintenance
of the unit. The power indicator light (A)
illuminates on the controller.
8
button twice. The indicator light (1) on the top
will illuminate and the current temperature will
flash. Press the arrow buttons (
set the desired temperature. Then press
button to confirm. (Temp range: 2°C -8°C)
temperature of tank 2, if desired (for CF761).
the actual temperature of the tank for 2
seconds, with the corresponding tank indicator
light illuminating.
press the corresponding tank button for 3
seconds. "OFF" will be displayed. To switch on
cooling, press and hold the tank button again.
Note: Do not drain the dispenser
by tipping the appliance.
Switch off and disconnect
from the power supply before
cleaning
UK
C
, ) to
5
2019/10/14 17:31