Kopp 8114.0202.0 Mode D'emploi page 14

Operating scenario: switching procedure (example:
receiver switching function):
For example, button 1 has been programmed.
Press button 1: radio receiver (switching function)
switches ON.
Press button 1 again: radio receiver (switching func-
tion) switches OFF.
Press master button „0": All programmed radio
receivers switch OFF.
Operating scenario: dimming procedure (example:
receiver dimming function):
For example, button 1 has been programmed.
Press button 1 briefly: radio receiver (dimming func-
tion) switches ON. (Full brightness level)
Press button 1 again briefly: radio receiver (dimming
function) switches OFF.
Press button 1 and hold down: radio receiver (dim-
ming function) switches ON and changes the lamp
brightness BRIGHT / DARK as long as it is pressed.
When the desired lamp brightness has been rea-
ched, release button 1.
Press master button „0": All programmed radio
receivers switch OFF.
Operating scenario: blind, awning, shutter control
(example: receiver blinds/series function):
One-button operation cannot be programmed (note
description of two-button operation).
Blinds would only move to one end position and
then no longer react.
Switching behavior of the series function of the
receiver as described in the switching procedure
example.
Operating scenario: button control (example: recei-
ver button/timer):
For example, button 1 has been programmed.
Radio receiver must be set to button mode.
Press button 1 briefly: radio receiver (button func-
tion) switches „ON" briefly.
Press button 1 and hold: radio receiver (button
function) switches „ON" and remains switched on as
long as the button is pressed.
Master button „0" has no function.
Operating scenario timer function (example: recei-
ver button/timer):
Radio receiver must be set on timer mode.
For example, button 1 has been programmed.
Press button 1 briefly: radio receiver (timer function)
switches „ON".
The time programmed into the radio receiver expires.
Radio receiver (timer function) switches „OFF" again
after the expiration of the programmed time.
Press button 1 > 400 msec: radio receiver (timer func-
tion) switches „OFF" again with the light switched on
before the expiration of the programmed time.
Constant light:
Switch off radio receiver (timer function) or allow the pro-
grammed time to expire if the receiver is switched on.
Press button 1 > 5 sec. and hold.
Light goes on after 400 msec., then goes out for 0.5
seconds after 5 seconds, and then goes on again.
Radio receiver (timer function) switches to constant
light in spite of programmed time.
Press button 1 briefly with constant light switched on.
Constant light is switched off again.
Master button „0" interrupts the execution of the
timer mode (time function)
11
G