Kopp 8114.0202.0 Mode D'emploi page 13

G
Manual radio transmitter mini for burglary alarm 4
in conjunction with radio receivers:
5: No function here
6: No function here
7: No function here
Button 1 and 2: can be used for switching, button,
and dimmer procedures and for
blinds control
Light emitting diode 9:
(Manual radio transmitter, manual radio transmitter
mini, manual radio transmitter for burglary alarm
(activated function with button 1 and 2)
Brief press of the button:
LED 9 illuminates briefly when pressed.
• for example during switching on/off
Long press of the button:
LED 9 illuminates until the button is released.
• for example, during dimming
LED 9 blinks:
• approximately 2 weeks before the battery capacity runs out.
• Then replace battery (battery replacement section)
LED 9 Feedback function for the manual radio
transmitter mini for burglary alarm 4
Only the manual radio transmitter for burglary alarm
has a bidirectional feedback function.
1x LED blinking: system armed
2x LED blinking: system disarmed
3x LED blinking: panic function activated
Error notifications by the manual radio transmitter
mini for burglary alarm 4:
LED 9 blinks quickly for 1 second:
a) no feedback received within 3 seconds by the
central burglary alarm unit / alarm station
b) panic button was used in conjunction with the
radio alarm station
Programming procedure and operation with radio
receivers
(For all function descriptions, follow separate opera-
ting instructions).
One-button operation
Activate desired radio receiver with „PROG" button.
Press desired number key of the manual radio trans-
mitter, manual radio transmitter mini, manual radio
transmitter for burglary alarm 1x
• For example, press button 1 = 1x.
Manual transmitter transmits a signal.
LED receiver must blink.
Programming procedure is automatically terminated.
It is possible to switch on/off, key, or dim a radio
receiver with the same button.
Note: In the following description, only button 1
and/or button 2 are mentioned as an example.
All number keys (with the exception of master button
„0") can be programmed and assigned by will.
10