Philips FC9250 Mode D'emploi page 20

English
20
Problem Possible cause
The light in the The filter cylinder needs
AutoClean button to be cleaned.
(specific types
only) or the filter-
cleaning reminder
light (specific types
only) flashes.
The suction power You have selected a low
is insufficient. suction power setting.
The filter cylinder is
clogged with dirt.
The motor protection
filter and/or the HEPA
filter are dirty.
The nozzle, hose or tube
is blocked up.
The infrared You have not inserted
remote control the batteries properly or
does not function. the batteries are empty.
All manuals and user guides at all-guides.com
- Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. By doing this, you help to preserve the environment.
guarantee and service
If you need service or information or if you have a problem, please visit the
Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone number in the worldwide
guarantee leaflet). If there is no Consumer Care Centre in your country, go
to your local Philips dealer.
troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your country.
Solution
Press the AutoClean button (specific types only) or
turn the filter-cleaning handle (specific types only) to
clean the filter cylinder.
Select a higher suction power setting.
Clean the filter cylinder (see chapter 'Cleaning and
maintenance').
Clean or replace the filters (see chapter 'Cleaning and
maintenance').
To remove the obstruction, disconnect the blocked-up
item and connect it (as far as possible) the other way
around. Switch on the vacuum cleaner to force the air
through the blocked-up item in opposite direction.
Insert the batteries properly or replace them. See
chapter 'Replacement'.