Trevi RC 80D6 DAB Manuel De L'utilisateur page 12

To keep the clock running and to store the time even during a temporary power
failure, insert two "AAA" batteries (not supplied) in the battery compartment (6) on
the bottom of the appliance following the polarity indications printed on the mobile.
Operation
Power On/Off-Standby:
1. Extend the telescopic antenna (8).
If the display does not show the time:
2. Press and hold for 3 seconds
If the display shows the time (Stand-by function):
3. Press /SOURCE (15) button;
4. Press and hold
Stand-by mode (the time and date are shown on the display);
5. Press and hold
the appliance (no display remains on the display).
Volume adjustment
Turn the VOLUME knob (2) to increase or decrease the volume.
Setting alarm
To set alarm 1 or 2, follow the next steps:
1. In radio mode, press the AL1 (11) or AL2 (16) button to enter the alarm settings
and confirm with the ENTER button (17);
2. Press the MEM-/SCAN- (12) or MEM +/SCAN+ (14) button to adjust the time and
confirm with the ENTER key (17);
3. Use the MEM-/SCAN- (12) or MEM+/SCAN+ (14) button again to adjust the
minutes and confirm with the ENTER key (17);
4. Use the MEM-/SCAN- (12) or MEM+/SCAN+ (14) button to select the duration
and confirm with the ENTER key (17);
5. Press the MEM-/SCAN- (12) or MEM+/SCAN+ (14) button to select the type of
ringtone (FM, DAB or BUZZER) and confirm with the ENTER key (17);
6. Press the MEM-/SCAN- (12) or MEM+/SCAN+ (14) button to select the fre
quency (once, daily, weekly, week-end only) and confirm with the ENTER key
(17);
7. Press the MEM-/SCAN- (12) or MEM+/SCAN+ (14) button to adjust the volume
and confirm with the ENTER key (17);
8. Press the MEM-/SCAN- (12) or MEM+/SCAN+ (14)
deactivate the alarm and confirm with the ENTER key (17).
Turn off the alarm
To stop the alarm completely (ringtone or radio) press
To stop the alarm sound, press the SNOOZE button (13); the interruption lasts 9
minutes, after which the alarm goes back on.
/SOURCE (15) button;
/SOURCE (15) button for 2 seconds to put the appliance in
/SOURCE (15) button for 2 seconds to completely switch off
button to activate or
/SOURCE (15) button.