Hotpoint Ariston LFSA+ 2284 Mode D'emploi page 22

Care and maintenance
EN
22
Clean the water inlet filter at the tap outlet regularly.
- Turn off the water tap.
- Unscrew the end of the water inlet hose, remove the filter and
clean it carefully under running water.
- Replace the filter and screw the water hose back into
position.
Cleaning the filters
The filter assembly consists of three filters which remove food
residues from the washing water and then recirculate the
water. They should be cleaned if you wish to achieve the best
results in every wash.
Clean the filters regularly.
The dishwasher should not be used without filters, or if the
filter is loose.
• After several washes, check the filter assembly and if
necessary clean it thoroughly under running water, using a
non-metallic brush and following the instructions below:
1. 1. 1. 1. 1. Turn the cylindrical filter C in an anti-clockwise direction
and pull it out (fig. 1).
2. 2. 2. 2. 2. Remove the cup filter B by exerting a slight pressure on the
side flaps (fig. 2).
3. 3. 3. 3. 3. Slide out the stainless steel plate filter A (fig. 3).
4. Inspect the trap and remove any food residue. NEVER
REMOVE the wash cycle pump (black detail) (fig. 4) . REMOVE REMOVE
REMOVE REMOVE
1
3
After cleaning the filters, replace the filter assembly and fix it in
position correctly; this is essential for maintaining the efficient
operation of the dishwasher.
Leaving the machine unused for extended
periods
• Disconnect the appliance from the electricity supply and
shut off the water tap.
• Leave the door of the appliance ajar.
• When you return, run a wash cycle when the dishwasher is
empty.
*
Only available in selected models.
NEVER NEVER NEVER NEVER
B
C
2
4