Publicité
Les langues disponibles
Les langues disponibles
Wash options*
The OPTIONS may only be set, modified or reset after
the wash cycle has been selected and before the Start/
Pause button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected was cycle (see Table of wash cycles) ,
the corresponding LED flashes rapidly 3 times.
If an option is selected which is incompatible with another
option or wash cycle selected previously, the incompat-
ible option light will flash 3 times and switches off, while the
most recently selected setting remains lit.
To deselect an option which has been set by mistake,
press the corresponding button again.
Half load using the upper rack
If there are not many dishes to be washed, a half load cycle
may be used in order to save water, electricity and detergent.
Select the wash cycle and press the HALF LOAD button: the
indicator light will illuminate and the wash cycle will take place
only in the upper rack.
Remember to load the upper rack only, and to
reduce the amount of detergent accordingly.
It is better to use powder detergent in this case.
This option is not compatible with the following
wash cycle: Rapid.
Table of options
Delayed
Auto Super Wash
Auto Normal
Daily A 60
Soak
Eco 50°C
Rapid
Crystal
*
A
B
Half
Start
Load
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
*
Delayed start
It is possible to delay the start time of the wash cycle by
3, 6 or 9 hours.
1: After selecting the desired wash cycle and any other
options, press the DELAYED START button. the indicator
light will illuminate.
2: Select the desired delay time by pressing the De-
layed Start button repeatedly; the wash phase (3 hours),
the drying phase (6 hours) and end (9 hours) indicator
lights will illuminate in succession.
If the Delayed Start button is pressed again, the option is
deselected and the indicator light switches off.
3. The countdown will begin once the Start/Pause but-
ton has been pressed. The selected delay period indi-
cator light flashes and the Start/Pause button stops flash-
ing (the light becomes fixed instead).
3. Once this time has elapsed, the DELAYED START
indicator light switches off and the wash cycle
begins.
The Delayed Start function cannot be set once a
wash cycle has been started.
*
Only available in selected models.
EN
19
Publicité
