Publicité
Les langues disponibles
Les langues disponibles
5 Setting up instructions
IMPORTANT!
Place humidifier in the upright position. When transporting a dehumidifier to site, allow it to stand
for 30 minutes before switching ON. This is necessary to allow the refrigerant system to stabilise
and avoid system damage.
Setting up the dehumidifier
Operate the dehumidifier in an enclosed area, as this creates a drying chamber. Close all doors, windows or areas that
open to external areas, to maximize the dehumidifier's water removal efficiency. Keep traffic through the drying chamber to
a minimum. Place the dehumidifier in the center of the room away from walls and furnishings. Do not allow the airflows to be
obstructed.
Illustration of correct positioning for best performance
Drainage
The dehumidifier pump connects to a plastic drainage hose. The hose is stored on the back of the appliance. Uncoil the entire
hose ensuring there are no kinks or restrictions and place the unattached end into a water vessel or run to outdoors.
Ensure that water which runs to outdoors does not create a slip hazard.
Water vessels must be checked regularly where used.
4
The position of drain water pipe would not be too high (< 4.5 m or 15 ft). Failure to do so may cause a
water backup in the pump resulting in leakage.
M1.2.BDP50-BDP70-BDP90.NLFREN - 03042024
16
EN
Publicité
