S&P TL-18 PTC Manuel D'instructions page 9

4. MAINTENANCE
• Before carrying out any maintenance work, make sure that the device has been disconnected from the mains and let the
heater cool down for a few minutes.
• Periodically, to prevent an accumulation of dust, clean the inlet and outlet air grilles (Fig 1b-d) with a damp cloth or a
vacuum cleaner. Never use petrol or aggressive and/or abrasive dissolvents to clean the device.
• If the air inlet fi lter is too blocked with dust, remove the screw that fi x the rear grille (Fig.2) and use two plastic fl ange to
remove it.
• You can clean the fi lter with cold water and install it again once completely dry.
• Do not immerse the device or spray with water.
• If the appliance is not to be used for any length of time, we recommend returning it to its original package and storing it
in a dry, dust-free place.
5. RELEVANT INFORMATION FOR THE DISMANTLING, RECYCLING OR ELIMINATION OF THE PRODUCT
AT THE END OF THE USEFUL LIFE
In the case of scrapping the appliance, the provisions corresponding to the disposal or recycling of the materials and com-
ponents must be respected.
List of the main heater materials:
• Internal and external laterals of PP plastic.
• PC led light cover.
• Aluminium impeller.
• Electric cables.
• Heating element (aluminium and ceramic).
• Motor (steel, aluminum and copper).
6. PUTTING OUT OF SERVICE AND RECYCLING
EEC legislation and our consideration of future generations mean that we should always recycle materials
where possible; please do not forget to deposit all packaging in the appropriate recycling bins. If your device
is also labeled with this symbol, please take it to the nearest Waste Management Plant at the end of its ser-
vicable life.
7. TECHNICAL ASISTANCE
• S&P's large Technical Service network will guarantee satisfactory technical assistance.
• If a fault is observed in the unit, please contact any of the mentioned technical service offi ces and they will attend to your
problem.
• Any modifi cation of the appliance by personnel not belonging to the Offi cial S&P Services will result in your guarantee
being void.
• For any queries regarding S&P products please contact any branch of our After Sales Service network if you are in Spain,
or your regular dealer in the rest of the world.
• To fi nd your nearest dealer, visit our website at www.solerpalau.com.
THE MANUFACTURER WILL NOT BE HELD LIABLE FOR DAMAGES TO PEOPLE AND/OR PROPERTY DUE TO NON-COM-
PLIANCE WITH THESE WARNINGS.
S&P RESERVES THE RIGHT TO MODIFY THE PRODUCT WITHOUT PRIOR NOTIFICATION.
EN
9