Beamz Pro KUBE20 Mode D'emploi page 5

Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and
have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from
shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to
the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water
might damage your unit. Leave the unit switched off until it has reached room temperature.
The label on the backside of the unit indicates the mains voltage to which it must be connected. Check that the mains voltage corresponds to this. Any
other voltage than the one indicated may cause irreparable damage to the unit. The unit must also be connected directly to the mains voltage and no
dimmer or adjustable power supply may be used.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to
avoid the risk of electrocution or fire.
Find menu and press
"Led_XXX" displayed on the screen is the WIFI address of the light fixture.
Scan the above QR code to install
On the phone, find WIFI and search WIFI address, and the words beginning with LED appear.
For example, "LED-XXX", click the link.
Turn on the APP installed on the phone and show the link is successful then you can control it.
Press to existing modes. Press
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press on the remote controller.
To adjust the strobe speed of the automatic program and the sound active program.
1. Press on the remote controller.
2. Press again to turn off the strobe.
To adjust the FADE speed of the automatic program, the sound active program and the manual
mode.
1. Press on the remote controller.
2. Press again to turn off the Fade mode.
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
1. Press on the remote controller.
1. Press one of the colours on the remote controller.
3. Press again to close your colour.
4. Press or to either increase or decrease the percentage of each colour.
to turn on WIFI.
APP first on mobile phone.
for power on.