Publicité
Les langues disponibles
Les langues disponibles
C
Cleaning and maintenance
Cleaning the wheels
Should threads or dirt block one of the wheels, gently insert a screwdriver under the
wheel axle and push up to pry it out. Remove any thread or object jamming the wheel.
Reposition the wheel by firmly pressing it back into its compartment. Make sure it
spins smoothly.
Clearing blockages
Small objects, carpet fibres, etc., can sometimes obstruct the vacuum cleaner.
•
In the event of a blockage or loss of suction during use, turn off the vacuum cleaner.
•
Detach the extension tube and/or vacuum tool to find the blockage and clear it.
Troubleshooting
Use this troubleshooting guide to resolve any common problems that you may encounter with
the unit. If the problem persists, do not use the unit and contact an authorised repair centre
to have it inspected and if necessary, repaired.
Problem
The unit does not
work.
The suction power
is weak, there is
no suction or the
motor vibrates.
Possible Cause
• The unit is not
connected to the mains
socket.
• The dust cup is full.
• The dust cup or filters
are not attached
properly.
• The extension tube/
vacuum tool is
blocked.
• The unit is switched
off.
• The extension tube,
vacuum tool, dust cup
or filters are partially
blocked or full of dust.
23
Solution
• Firmly insert the plug into the mains
socket. Place the On/Off switch in the
ON position to switch it on. If the unit
is still not working, contact a qualified
technician to get it inspected.
• Empty the dust cup.
• Re-attach the dust cup and filters.
• Turn off the unit and remove the
blockage.
• Place the On/Off switch in the ON
position to switch the unit on.
• Remove the blockage.
• Clean the filters.
• If necessary, replace the filter with
a new one.
EN
Publicité
