BEA 90/25-552E Notice D'emploi page 7

Device-specific additional instructions for nailer
4 Filling the magazine

Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.

Check fasteners for proper condition.

Turn the tool upside down, press the lock 1 and pull the
lower slide 2 backwards. Release the locking button 1,
insert the clamps 3 into the magazine. Then push the lower
slide forward again.
5 Removing stuck fasteners from the driving channel

Disconnect the tool from the compressed air supply. Open the magazine as described in chapter 4 and
remove the staples. Then reconnect the tool to the compressed air supply and refill it with staples
6 EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 28927-13:2022-02 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
90/25-552E
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7