Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EASY, 3-STEP INSTALLATION
ATTACH MOUNT ONTO BIKE FRAME
1
1. Remove four (4) screws from back of
mount using 5mm Allen wrench.
2. Place front of mount around seat
tube of bike. Insert back of mount
to front of mount, insert screws.
Do not fully tighten. Do not place
around brake and derailleur cable
and housing.
ATTACH RACK TO CARRIER
2
1. Turn the carrier upside down. Insert
suspension rack bars through holes
as shown below.
2. Insert the locking pin through the
holes under the carrier with the lever
in the unlocked position until it snaps
into place.. Turn the pin 180 degrees
untill it snaps into the locked position.
UNLOCKED
CLICK RACK INTO MOUNT
3
1. Slide the ends of the carrier rack into the top holes on the mount. Once secured,
you will hear a click. This means the carrier rack is secured to the mount.
2. Slide the loose mount up or down until there is about 6 inches between rear wheel
and bottom of carrier. Be sure mount is centered along rear wheel facing forward.
3. Tighten the screws on the mount until mount will not slip up, down, or side to side.
4. Tighten fasteners securely, and check them frequently.
WARNING
Do not modify carrier rack or bicycle. If carrier rack will not fit on your bicycle, consult your local bicycle dealer or
call our Customer Service at 1.800.456.BELL for assistance.
4 | English
1
2
LOCKED
SEAT PAD INSTALLATION
Place seat pad into bottom of child carrier. Thread retention
harness through seat pad. Insert all four seat pad plugs into the
bottom of the child carrier.
RETENTION HARNESS:
3-POINT HARNESS
• Use harness slots at
child's shoulders.
• Shoulder straps should fit snugly –
so that only one finger can fit
between harness and shoulder.
• Ensure top of chest clip is
positioned at armpit level.
• Ensure harness forms the
shape of a V.
• Connect each buckle end and
click to secure.
• To release, pinch each side
of buckle and pull apart
buckle ends.
WARNING
Child can fall out of child carrier if harness is not correctly
fastened and adjusted.
REFLECTOR INSTALLATION
To install the reflector, remove backing paper on the reflector
and place the sticky side onto the hexagonal molded imprint on
the back center of the child carrier. Press to adhere.
FOOT REST INSTALLATION
To insert foot rest, insert top hook into preferred height. Slide
bottom tab into slot and pinch both together at the same time
while pushing the foot rest into place. Pull at them gently to
ensure they are secured properly. To remove foot rest, pinch
the hook and tab at the same time and pull up, freeing the
bottom tab. Then pull the top hook free.
FOOT STRAP ATTACHMENT
1. Loop one piece of Velcro
®
through each foot rest and
attach back onto itself.
2. Insert top hooks of foot rests into opening along leg. Must
be at least three notches from bottom. Push to lower tabs
through respective opening and click into place. Lower
hook tabs need to be slightly lifted when inserted into slot.
5 | English
Publicité
Table des Matières
