Publicité
Les langues disponibles
Les langues disponibles
INITIAL OPERATION
• Protect the measuring tool
against moisture and direct
sun irradiation.
• Do
not
measuring tool to extreme
temperatures or variations in
temperature. As an example,
do not leave it in vehicles for
longer periods. In case of large
variations in temperature, allow
the measuring tool to adjust to
the ambient temperature before
putting it into operation. In case
of extreme temperature or
variations in temperature, the
accuracy of the measuring tool
can be impaired.
• Avoid heavy impact to or
dropping the measuring tool.
After severe exterior effects to
the
measuring
recommended to carry out an
accuracy check (see "Accuracy
Check and Calibration of the
Grade
Measurement"
"Accuracy
Distance
Measurement"
page 24) each time before
continuing work.
Switching On and Off
For switching on the measuring
tool, the following possibilities are
given:
Operation
expose
tool,
it
Check
of
- Pressing the On/Off button 8:
The measuring tool is switched
on and in length measurement
mode.
activated.
the
- Pressing the measuring button
2: Measuring tool and laser are
switched on. The measuring
tool is in length measurement
mode. When the measuring tool
is inserted in the digital level
attachment
measurement
activated.
To switch off the measuring tool,
press the On/Off button 8 for a
few seconds.
When
measuring tool is pressed for
approx. 5 minutes, the measuring
tool automatically switches off to
save the batteries.
is
When the angle is not changed for
approx. 5 minutes when in the
"Grade measurement" operating
mode,
and
automatically switches off to save
the
batteries.
on
When switching off automatically,
all stored values are retained.
-20-
The
laser
24,
the
function
no
button
the
measuring
is
not
grade
is
on
the
tool
Publicité
