Parker 20H-FUEL Guide D'utilisation page 9

2.5 Receiving and Inspecting the Equipment
On receipt of the equipment carefully inspect the packaging for damage. If the packaging is damaged inform the delivery company immediately
and contact your local Parker Hannifin office.
2.5.1 Storage
If the equipment is to be stored prior to installation, do not remove it from the packaging. Ensure that it is stored in an upright position as
indicated by the arrows on the packaging.
Do not attempt to lift the generator by yourself. It is recommended that the generator be carried by a minimum of two persons or transported
on a pallet truck.
Note. The storage area should be secure and the environmental conditions should fall within those specified in the technical specification.If the
generator is stored in an area where the environmental conditions fall outside of those specified, it is essential that it be moved to its final
location (installation site) and left to stabilise prior to unpacking. Failure to do this could cause condensing humidity and potential failure of the
generator.
2.5.2 Unpacking
Once ready to install, remove the equipment from the packaging and check for signs of damage. Verify that the items specified on the hydrogen
product packaging list have been included with the shipment. If any items are missing or damaged please contact your local Parker Hannifin
office. Do not attempt to power up the generator.
2.5.3 Overview of the equipment
Key:
1 Control panel
2 Options board connection port
O Vent (<250ml/min)
3
2
Excess H vent (<1ml/min)
4
2
5 Water bottle vent
6 Water drain
6
6
7
8
9
7 Auto water fill connection (factory or field fit option)
8 Overflow drain
9 Fused IEC 320 inlet socket and ON/OFF switch
10 Water bottle spillage drain
11 Environmental filter
12 Hydrogen Outlet
11
12
10