Parker 20H-FUEL Guide D'utilisation page 7

2.2 Approvals
Safety and Electromagnetic Compatibility (EMC)
LISTED
LABORATORY
EQUIPMENT 84NA
2.3 Materials of Construction
Facia and Covers
Chassis
Seal Materials
Display Bezel
Display Facia
Deionised Water Circuit Tubing
Hydrogen Circuit Tubing
Inlet/ Outlet Circuit Tubing
Satellite filter
Barbed Fittings
Water Reservoir
Float
Conductivity Sensor
Floats
Manifold, Bowl and Spigot
JG Fittings
Conductivity Probes
Water Bottle to Pump Fitting
Pressure Switch
PEM Cell
Desiccant Cartridge (adsorbant)
Mounting Feet
4
This equipment has been tested and complies with the following European Standards:
EN61010-1: 2001 — Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory use - Part 1:
General Requirements.
EN61326: 2006 — Electrical Equipment for Measurement, Control, and Laboratory use, EMC Requirements.
EN50366: 2003 (+ A1: 2006) — Household and similar electrical appliances. Electromagnetic fields. Methods for evaluation and
measurement.
IEC 62233: 2008 — Measurement methods for electromagnetic fields of household appliances and similar apparatus with regard
to human exposure.
This equipment has been tested to and complies with the following standard:
UL 61010-1 2nd Edition, "Electrical Equipment for Laboratory Use; Part 1: General Requirements.
CAN/CSA C22.2 No.61010-1 2nd Edition, "Electrical Equipment for Laboratory Use; Part 1: General Requirements.
Noryl FN150 (R4G334/ AE251/1 Trimite coated)
Mild Steel (Epoxy Powder Coated)
Nitrile, Viton, EPDM, PTFE (tape)
PA-765 ABS
Polyester film (Lumirror S10)
Tygon, Natural PTFE
Natural PTFE
Cleaned* Stainless Steel 316 (Inlet/ outlet Piping)
Polypropylene
Polyethylene
Polyvinyl Chloride
Natural Polycarbonate
Acetyl
Clean 316 Stainless Steel
Platinum and Titanium
Molecular Sieve MS 544/Clear Polycarbonate Cal. 300EP-22
Polyamide reinforced nylon and plated mild steel