Publicité
Les langues disponibles
Les langues disponibles
CAUTION: HOT WATER. Do not remove the brew basket or vessel while brewing.
CAUTION: STEAM. Do not touch steam vents or the top of the brewer while brewing.
CAUTION: The brew basket is hot after brewing. Always allow the brewer to cool down before cleaning.
Fig. 16
DRIP STOP
NOTE: If the Drip Stop is closed before you begin a
brew, the brewer will notify you with 5 beeps and the
Drip Stop indicator will illuminate. Set the Drip Stop
to the open position and select your brew type.
CAN'T WAIT FOR THAT FIRST CUP TO BE READY?
When brewing a carafe, close the Drip Stop to pause the
brew cycle and pour a cup. Promptly replace the carafe and
open the Drip Stop to complete the brew. (Fig. 16)
NOTE: If you forget to open the Drip Stop, the Ninja Coffee
Bar
System will pause the brew, and after 20 seconds it
®
will give you a friendly audible reminder. After 6 minutes, the
brew will be canceled.
CAN'T WAIT FOR THE LAST FEW DROPS?
When the brew cycle is complete, set the Drip Stop to the
closed position to stop dripping from the brew basket.
NOTE: While the Drip Stop is closed, the Drip Stop indicator
will light up in the bottom right hand corner of the control
panel.
NOTE: Remember to open the Drip Stop when you are ready
to brew again. If you forget, your Ninja Coffee Bar System
will give you a friendly audible reminder.
BREWING COFFEE
NOTE: Each brew has a pre-infusion cycle with
varying times. The brew will begin, stop, and be
quiet for a short period of time before it begins
again. This process is used to evenly saturate the
coffee grounds.
NOTE: For hotter coffee, rinse the coffee cup, mug, or
thermal carafe with hot water prior to brewing.
CAUTION: Ensure the coffee cup, mug, or thermal
carafe is completely empty before starting a brewing
cycle. Starting a brewing cycle with coffee in the
vessel could cause an overflow.
Fig. 17
CUSTOM BREWS:
CLASSIC & RICH
Classic Brew - For a smooth, balanced flavor.
Rich Brew - For a coffee that is richer than Classic
Brew and still smooth, with more room for milk and
cream.
1
After filling the water reservoir and adding ground
coffee to the filter, be sure the Drip Stop is open and
the reservoir, basket, and filter are securely in place.
2
Use the Multi-Serve dial to select the size of coffee you
would like to brew. Place the empty vessel you would
like to brew into underneath the brew basket.
NOTE: If making a single cup, lower the Multi-Serve
Cup Platform down and center the cup or mug on the
platform. Please ensure you are using at least a 12 oz.
cup for the Cup size, 14 oz. cup for the XL Cup size, 16
oz. travel mug for the Travel Mug size, and 20 oz. travel
mug for the XL Multi-Serve size.
3
Press the Classic Brew or Rich Brew button and the
brew will begin. (Fig. 17, Fig. 18) Press the Classic
Brew or Rich Brew button again to cancel the brew.
NOTE: The brew will begin, stop, and be quiet for
a short period of time before it begins again. This
process is used to evenly saturate the coffee
grounds.
NOTE: Do not remove water reservoir, brew basket, or
vessel while brewing.
4
The Ninja Coffee Bar System will beep to signal a
completed brew.
NOTE: Rich Brew will use slightly less water and yield
slightly less brewed coffee than Classic Brew.
Fig. 18
ninjakitchen.com
18
Publicité
