Télécharger Imprimer la page

Awanti BCA3115S3S Manuel D'instructions page 9

Publicité

Les langues disponibles

Les langues disponibles

 BEFORE USING YOUR BEVERAGE COOLER
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
1
Instruction Manual
3
Beverage Shelves (2 Glass shelves / 1 Wire shelf)
1
Wire Storage Basket
2
Keys
1 Set
Hinges for Door Swing Reversal
1
Stainless Steel Handle
Before connecting this appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
 Clean the interior surface with lukewarm water using a soft cloth.
 INSTALLATION OF YOUR BEVERAGE COOLER
This appliance is designed to be for free standing installation or built-in (fully recessed).
Place your Beverage Cooler on a floor that is strong enough to support it when it is fully
loaded. To level your Beverage Cooler, adjust the front leveling legs at the bottom of the
Beverage Cooler.
Locate the Beverage Cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the unit not to
perform properly.
Avoid locating the unit in moist areas.
Plug the Beverage Cooler into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified electrician
or an authorized Avanti Products service center.
BUILT – IN CABINET INSTRUCTIONS
This unit is designed for both built-in or free standing installation. If you plan to use this unit in a built-
in application, please follow the requirements shown below.
Unit Dimensions
Width
Depth
(with handle)
Depth
(without handle)
Height
INSTALLATION INSTRUCTIONS
Figure shown →
IN (min)
MM (min)
"
380 mm
15
24 ¾"
630 mm
23 ¼"
590 mm
34"
864 mm
Figure shown
Cabinet Opening Dimensions
IN (min)
Width
15 ¼"
Depth
24"
Height
35"
9
MM (min)
388 mm
610 mm
889 mm

Publicité

loading